Cell Phone Charging DIY Kit

$19.99

note

accessories

packing list

  • Solar chager

Availability: 3333 In Stock

3333 in stock

Quantiy:
Compare

Description

Features:

Voltage:6V Current: 210MA Process: Epoxy Material: high rate solar cell epoxy resin AB glue, PCB or fiberglass backplane Size: 133*73MM Package include: 1*Solar panel

Solar charger

Solar Charger This is a supper mini Solar Lipo charger based on the CN3065 – a single lithium battery charge management chip. This Solar charger provides you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargeable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the Solar charger and your battery into the other and you are good to start charging! The output of the Solar Charger is intended to charge a single polymer lithium-ion cell. The load should be connected in parallel with the battery. By default, the Solar charge comes set to a maximum charge current of 500mA with a maximum recommended input of 6V (minimum 4.4V). It’s recommended that batteries not be charged at greater than their capacity rating.

Features:

Solar panel input: 4.4-6V Max charge current: 500Ma Interface: 2-pin JST connectors(or PH2.0) Short circuit protection Continuous Charge Current Up to 500mA Battery status indication ( Red : Charging , Green: Charged ) Micro-USB Connector

Package A Include

1* Solar Panel 1* Solar Charger 3*Cable

1S Power display

How to use: Connect the positive and negative terminals of the display board to the positive and negative terminals of the battery under test, and the digital tube displays the real-time battery power Display battery parameters: (Remarks: N is the number of battery cells) (The following data is a reference value, there will be an error range of about 2%, do not shoot if high accuracy is required) The battery voltage is greater than N × 3.3V, with 1 grid lit The battery voltage is greater than N × 3.5V, with 2 grids on The battery voltage is greater than N × 3.7V, with 3 grids on The battery voltage is greater than N × 3.9V, with 4 grids on The battery voltage is less than N × 3.3V, and the four-segment display is all off, indicating that the battery is below 3.3V, and it is time to charge the battery.

1S Power display

How to use: Connect the positive and negative terminals of the display board to the positive and negative terminals of the battery under test, and the digital tube displays the real-time battery power Display battery parameters: (Remarks: N is the number of battery cells) (The following data is a reference value, there will be an error range of about 2%, do not shoot if high accuracy is required) The battery voltage is greater than N × 3.3V, with 1 grid lit The battery voltage is greater than N × 3.5V, with 2 grids on The battery voltage is greater than N × 3.7V, with 3 grids on The battery voltage is greater than N × 3.9V, with 4 grids on The battery voltage is less than N × 3.3V, and the four-segment display is all off, indicating that the battery is below 3.3V, and it is time to charge the battery.

 

 

 

 

 

 


 

 

Weight 0.1 g
Dimensions 3.6 × 3.2 cm
Brand Name:

Heltec Automation

Size

130*73MM

Material

Monocrystalline Silicon

Reviews

There are no reviews yet.

Be the first to review “Cell Phone Charging DIY Kit”

Your email address will not be published. Required fields are marked *